Next Article in Journal
A Partially Distributed Intrusion Detection System for Wireless Sensor Networks
Previous Article in Journal
Development and Evaluation of an Improved Technique for Pulmonary Function Testing Using Electrical Impedance Pneumography Intended for the Diagnosis of Chronic Obstructive Pulmonary Disease Patients

Sensors 2013, 13(11), 15861-15862; doi:10.3390/s131115861

Correction
Correction: Grenez, F., et al. Wireless Prototype Based on Pressure and Bending Sensors for Measuring Gait Quality. Sensors 2013, 13, 9679–9703
Florent Grenez 1, María Viqueira Villarejo 2, Begoña García Zapirain 2 and Amaia Méndez Zorrilla 2,*
1
Computer Science Department, ICAM University, 6 rue Auber-59000 Lille, France
2
DeustoTech-Life Unit, Deusto Institute of Technology, University of Deusto, Avda. de las Universidades, 24, Bilbao 48007, Spain; E-Mail: mbgarciazapi@deusto.es
*
Author to whom correspondence should be addressed; E-Mail: amaia.mendez@deusto.es; Tel.: +34-944-139000 (ext. 2051); Fax: +34-944-139101.
Received: 12 September 2013; in revised form: 29 September 2013 / Accepted: 29 September 2013 /
Published: 21 November 2013

In [1], we would like to change “Gate” to “Gait” in the title, which should read “Prototype Based on Pressure and Bending Sensors for Measuring Gait Quality”. In Figure 7 we would like to change the analog inputs. The measurements should be between the sensor and the resistance, and not after the resistance. The revised figure is shown below.

The authors would like to apologize for any inconvenience caused to the readers by these changes.

Reference

  1. Grenez, F.; Villarejo, M.V.; Zapirain, B.G.; Zorrilla, A.M. Wireless Prototype Based on Pressure and Bending Sensors for Measuring Gate Quality. Sensors 2013, 13, 9679–9703. [Google Scholar]
Sensors 13 15861f7 1024
Figure 7. General circuit.

Click here to enlarge figure

Figure 7. General circuit.
Sensors 13 15861f7 1024
Sensors EISSN 1424-8220 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert