Next Article in Journal
Sensitivity Analysis of Parameters Governing the Recovery of Methane from Natural Gas Hydrate Reservoirs
Previous Article in Journal
Effects of Degree of Superheat on the Running Performance of an Organic Rankine Cycle (ORC) Waste Heat Recovery System for Diesel Engines under Various Operating Conditions
Previous Article in Special Issue
Turbulent Flow Characteristics and Dynamics Response of a Vertical-Axis Spiral Rotor

Energies 2014, 7(4), 2146-2147; doi:10.3390/en7042146

Correction
Correction: Márquez-Domínguez, S.; Sørensen, J.D. Fatigue Reliability and Calibration of Fatigue Design Factors for Offshore Wind Turbines. Energies 2012, 5, 1816–1834
Sergio Márquez-Domínguez * and John D. Sørensen
Aalborg University, Sohngaardsholmsvej 57, DK-9000 Aalborg,Denmark; E-Mail: jds@civil.aau.dk
*
Author to whom correspondence should be addressed; E-Mail: smd@civil.aau.dk; Tel.: +45-9940-8575; Fax: +45-9940-8552.
Received: 29 January 2014 / Accepted: 26 February 2014 / Published: 1 April 2014

The authors wish to make the following correction to this paper [1]. On page 1831, the titles of Tables 18 and 19 were incorrect, and should be changed from to the correct versions as follows:

The authors would like to apologize for any inconvenience caused to the readers by this change.

Reference

  1. Márquez-Domínguez, S.; Sørensen, J.D. Fatigue Reliability and Calibration of Fatigue Design Factors for Offshore Wind Turbines. Energies 2012, 5, 1816–1834. [Google Scholar]
Table Table 18. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Inspections with the eddy current technique.

Click here to display table

Table 18. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Inspections with the eddy current technique.
β/number of inspections012410
2.53.42.72.31.31
3.16.15.04.12.81
Table Table 19. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Close visual inspection.

Click here to display table

Table 19. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Close visual inspection.
β/number of inspections012410
2.53.42.72.31.31
3.16.15.04.12.81
Table Table 18. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Close visual inspection.

Click here to display table

Table 18. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Close visual inspection.
β/number of inspections012410
2.53.43.02.72.31
3.16.15.35.03.61.3
Table Table 19. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Inspections with the Eddy Current technique.

Click here to display table

Table 19. Required FDF values for minimum cumulative reliability level. SN-curve: “With cathodic protection”. Inspections with the Eddy Current technique.
β/number of inspections012410
2.53.43.02.72.31
3.16.15.35.03.61.3
Energies EISSN 1996-1073 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert