Biopolymers for 3D Printing
A special issue of Polymers (ISSN 2073-4360). This special issue belongs to the section "Circular and Green Polymer Science".
Deadline for manuscript submissions: 31 December 2024 | Viewed by 195
Special Issue Editors
Interests: 3D bioprinting; 4D printing; biomaterials; biomedical applications; rheology
Special Issues, Collections and Topics in MDPI journals
Special Issue Information
Dear Colleagues,
Biopolymers are a category of polymers that are derived from natural sources with good biodegradability. Some representative biopolymers include polylactic acid (PLA), polyhydroxyalkanoates (PHA), chitosan, and cellulose, which have been extensively used as build materials in different three-dimensional (3D) printing methods, such as fused deposition modeling (FDM), direct ink writing (DIW), stereolithography (SLA), and powder bed fusion. This Special Issue will focus on cutting-edge research advances in the area of biopolymers for 3D printing applications. Specific topics of interest include but are not limited to, biopolymer development, 3D printing methods for biopolymers, biomedical applications, process optimization in biopolymer printing, and recycling of 3D-printed biopolymers. Original research and review articles are welcome.
Dr. Yifei Jin
Dr. Kaidong Song
Guest Editors
Manuscript Submission Information
Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the special issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 100 words) can be sent to the Editorial Office for announcement on this website.
Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-blind peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Polymers is an international peer-reviewed open access semimonthly journal published by MDPI.
Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2700 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.
Keywords
- biopolymer
- 3D printing
- biomedical application
- material design
- biopolymer recycling
