Use of Modern Materials in Technological Processes Accompanied by Frictional Heating (Volume II)

Dear Colleagues,

Friction is widely used in grinding, welding, cutting, and other technological processes. Thermal phenomena accompanying friction have a decisive influence on both the course of these processes and on the quality of the result. Due to the extensive use in the industry of alloys based on magnesium, titanium, and aluminum, as well as new marks of steel and other materials sensitive to thermal effects, the thermal processes of friction are extremely important. In particular, it is necessary to note the use of friction during braking. The frictional materials used in brake units should provide the necessary value and stability of the coefficient of friction. The problem is that in heavy braking modes, the coefficient of friction, as well as the material properties, become thermally sensitive. In this case, one way to improve the frictional properties is using the thermal barrier coating (TBC) method.

The physical and mechanical state of the surface layers of rubbing elements is determined not only by the contact temperature, which can be measured experimentally, but by the entire space–time temperature field. Gradients of temperature and the rate of changes in the temperature field have the most value. These factors have unambiguous functional relationships with the kinematic and dynamic parameters of the friction mode, material properties, cooling intensity, and many other parameters. There is a need for a comprehensive study, using all available methods, to investigate the temperature field and the resulting stress state. Reliable results can be obtained only with a reasonable combination of theory and experiment.

Prof. Dr. Aleksander Yevtushenko
Prof. Dr. Michal Kuciej
Guest Editors

Dr. Katarzyna Topczewska
Guest Editor Assistant

Manuscript Submission Information

Manuscripts should be submitted online at www.mdpi.com by registering and logging in to this website. Once you are registered, click here to go to the submission form. Manuscripts can be submitted until the deadline. All submissions that pass pre-check are peer-reviewed. Accepted papers will be published continuously in the journal (as soon as accepted) and will be listed together on the Special Issue website. Research articles, review articles as well as short communications are invited. For planned papers, a title and short abstract (about 250 words) can be sent to the Editorial Office for assessment.

Submitted manuscripts should not have been published previously, nor be under consideration for publication elsewhere (except conference proceedings papers). All manuscripts are thoroughly refereed through a single-anonymized peer-review process. A guide for authors and other relevant information for submission of manuscripts is available on the Instructions for Authors page. Materials is an international peer-reviewed open access semimonthly journal published by MDPI.

Please visit the Instructions for Authors page before submitting a manuscript. The Article Processing Charge (APC) for publication in this open access journal is 2600 CHF (Swiss Francs). Submitted papers should be well formatted and use good English. Authors may use MDPI's English editing service prior to publication or during author revisions.