Search Results (1)

In this study, the novel coaxial-annulus-argon-assisted (CAAA) atmosphere is proposed to enhance the machining capacity of the water-jet-guided laser (WJGL) when dealing with hard-to-process materials, including ceramic matrix composites (CMCs) and chemical-vapor-deposition (CVD) diamond. A theoretical model was developed to describe the two-phase flow of argon and the water jet. Simulations and experiments were conducted to analyze the influence of argon pressure on the working length of the WJGL beam, drainage circle size, and extreme scribing depth on ceramic matrix composite (CMC) substrates. A comparative experiment involving coaxial annulus and helical atmospheres revealed that the coaxial annulus atmosphere disrupts the water jet proactively, while effectively maintaining the core velocity within the confined working length and enhancing the processing capability of the WJGL beam. Single-point percussion drilling experiments were performed on a CMC substrate to evaluate the impact of machining parameters on hole morphology. The maximum depth-to-width ratio of the groove and depth-to-diameter ratio of the hole reached up to 41.2 and 40.7, respectively. The thorough holes produced by the CAAAWJGL demonstrate superior roundness and minimal thermal damage, such as fiber drawing and delamination. The average tensile strength and fatigue life of the CMCs specimens obtained through CAAAWJGL machining reached 212.6 MPa and 89,463.8 s, exhibiting higher machining efficiency and better mechanical properties compared to femtosecond (194.2 MPa; 72,680.2 s) and picosecond laser (198.6 MPa; 80,451.4 s) machining. Moreover, groove arrays with a depth-to-width ratio of 11.5, good perpendicularity, and minimal defects on a CVD diamond were fabricated to highlight the feasibility of the proposed machining technology. Full article