Synthesis, Characterization and Antimicrobial Activity of New 1,2,3-Selenadiazoles

The commercially available aromatic polyketones 1a-d were utilized for the synthesis of the multi-arm1,2,3-selenadiazole derivatives 3a-d. The preparation starts with the reaction between compounds 1a-d and p-toluenesulfonyl hydrazide to give the corresponding tosylhydrazones 2a-d. Subsequent reaction with selenium dioxide leads to regiospecific ring closure of the tosylhydrazones to give the target multi-arm 1,2,3-selenadiazole derivatives in high yield. A 1,2,3-selenadiazole derivative 3e containing an epoxide ring was also prepared. The structures of all the synthesized compounds were confirmed on the basis of spectral and analytical data. The compounds were screened in vitro for their antimicrobial activity against various pathogenic bacterial and Candida strains obtained from King Abdullah Hospital in Irbid -Jordan. Compounds 3a, 3c and 3e were found to be highly active against all the selected pathogens. Compound 3e showed an inhibition zone of 13 mm against the highly resistant P. aruginosa.


Introduction
Selenium containing heterocyclic compounds are of interest due to their biological and synthetic applications. 1,2,3-Selenadiazoles and derivatives are well known and have attracted attention as versatile synthetic intermediates [1][2]. Many substituted 1,2,3-selenadiazoles and derivatives have been prepared to-date and some of them show high antibacterial activity [3][4][5][6]. The antifungal activity of other substituted 1,2,3-selenadiazoles has also been determined [6][7][8]. It has been found that the introduction of a 1,2,3-selenadiazole ring to molecules of known biological activity compounds changes their activities and in some cases leads to an increase in their biological activity [9]. Other heterocyclic compounds containing five membered rings like triazole, oxazole, pyrazoline, pyrazole and thiazole have been found to be biologically active substances [3,[11][12]. These ring systems are present in numerous antiparasitic, fungicidal, antihelminitic and antiinflammatory drugs.
β-Lactam antibiotics derivatized with a 1,2,3-thiadiazole-5-mercapto moiety have been found to be active against Gram-negative bacteria such as Pseudomonas aeruginosa. 4-Methyl-1,2,3-selenadiazole-5-carboxamides have been described to inhibit tumor cell colony formation [13][14]. In the area of antibacterial therapeutics, resistance to currently available drugs is progressively limiting their utility in treating bacterial infections. This problem can be solved by discovering novel pharmaceutical drugs that inhibit novel targets. Advances in molecular microbiology and genomics have led to the identification of numerous bacterial genes that are encoding for novel proteins, that could potentially serve as novel targets for antibacterial compounds. Regulatory proteins such as the two-component histidine kinases, involved in bacterial signal transduction, have recently gained considerable attention as one such class of potential targets [15].
As a continuation of our work on the synthesis of heterocyclic compounds containing 1,2,3thiadiazoles and 1,2,3-selenadiazoles [16][17][18], we have set out to synthesize a new group of heterocyclic compounds containing 1,2,3-selenadiazole derivatives from the corresponding ketones 1a-d, respectively, hoping to obtain biologically active compounds with potential use in the manufacture of pharmaceutical drugs. In this paper we present new data on the antimicrobial activities of heterocyclic compounds containing 1,2,3-selenadiazole rings and the corresponding tosylhydrazones.

Results and Discussion
The target 1,2,3-selenadiazole derivatives 3a-d were prepared from the corresponding tosylhydrazones 2a-d as shown in Scheme 1. The synthetic procedure started from the commercially available polyketones 1a-d. They were transformed into the target heterocyclic compounds by the reaction of the tosylhydrazones with selenium dioxide, as previously described by Lalezari et. al. [19][20]. Compound 3e was prepared by reaction of 4-(1,2,3-selenadiazole-4-yl)phenol [16] and epichlorohydrin, as shown in Scheme 2.   The activity of these heterocyclic compounds and their tosylhydrazone precursors was tested against some human pathogenic microbes including Gram-positive (Staphylococcus aureus), Gramnegative (Escherichia coli, local resistant Pseudomonas aeruginosa and a reference Pseudomonas aeruginosa ATCC 27853) and Candida albicans by two methods, namely by the hole diffusion (see Table 1) and by the paper disk method (see Table 2).
From the results obtained from the two methods (Tables 1 and 2), it was found that some of the tested heterocyclic compounds were highly active even at low concentrations (ie., at 0.005 g/mL or less). Both methods indicated that the sensitivity of the highly resistance Pseudomonas. aeruginosa and the sensitivity of a local, highly resistant clinical isolate, collected from King Abdullah Hospital at Jordan University of Science and Technology, to some of these heterocyclic compounds is high.
The extracts of compounds 3a, 3c and 3e in dimethyl sulfoxide (DMSO) are active against all the tested pathogens, with a (8-19 mm) inhibition zone diameter, when using the hole diffusion technique, as indicated in Table 1. Pseudomonas. aeruginosa, a local isolate highly resistant to all domestic antibiotics (amikacin, carbenicillin, cefoperazone, gentamicin, tobramycin), used in the clinical labs of King Abdullah Hospital was found to be more sensitive to compound 3e. This isolate was also sensitive to compounds 3a and 3c (at 0.01 g/mL) and to 3e (at 0.005 g/mL). The solvent showed no activity against any of the tested pathogens.  As indicated from the present data, these synthetic heterocyclic compounds show potential as novel antimicrobial agents, compared with the reference antibiotic tobramycin. Most of these heterocyclic compounds are active against Candida albicans, a eukaryotic cell, so these synthetic heterocyclic compounds should be studied further in the context of antitumor or anticancer drugs (chemotherapeutic agents).

General
The melting points (m.p.) were determined on an Electro Thermal digital melting point apparatus. The solvents were purified by standard procedures. Infrared (IR) spectra were recorded using a NICOLET 410 FT-IR spectrometer (in cm -1 ). The IR spectra of pure substances were measured as KBr-pellets. NMR spectra were recorded on a Jeol JNM-ECP400 FT-NMR system at 400 MHz ( 1 H-NMR) and 100 MHz (  General procedure for the preparation of the 1,2,3-selenadiazole derivatives 3a-d [16,22] Tosylhydrazone 2a-c or 2d (0.36 mmol) was mixed with an equivalent amount of selenium dioxide powder (0.72 mmol) or (1.08 mmol), respectively, and sodium sulfate (3.0 g) in 1,4-dioxane (20 mL) under vigorous stirring and gentle heating at 35-45°C. The solution was kept in the dark and the reaction progress was monitored by TLC, showing that the reactions complete within about 20 hours. After reducing in vacuo the volume of the reaction mixture to two thirds of its original volume, distilled water (30 mL) was added, and the ensuing mixture was extracted with chloroform (3x20 mL).. The combined chloroform layers were dried over sodium sulphate. The crude product was obtained after solvent removal in vacuo. Column chromatography using toluene/diethyl ether (7:3) as eluent was used to separate the product, which can be recrystallized subsequently from chloroform/hexane.

Microbiology
The filter paper disk and the hole diffusion methods were used to measure the inhibitory activity as indicated by the diameter of the inhibition zone [21][22]. The filter paper disk method was carried out as follows: Whatman III filter paper puncture disks 5 mm were saturated with different concentrations of the heterocyclic compounds to be tested. They were dried in an oven at 60°C for 12 hours. The dried disks were placed on already cultured nutrient agar plates concomitantly with the pathogens. The diameter of the clear zone around the disks was measured after 48 hours of incubation at 37°C. The absence of a clear zone around the disks indicated inactivity.
The hole method was carried out as follows: for each concentration, 100 µL of the heterocyclic compounds were placed in 5 mm diameter wells on nutrient agar inoculated spontaneously with the pathogens to be tested against. The plates were incubated at 37°C for 48 hours. The clear zone around the wells was measured as inhibition zones. The absence of a clear zone around the well was taken as inactivity. In both methods, DMSO was used as a solvent to prepare the solutions of the heterocyclic compounds.