Next Article in Journal
Growth of WS2 flakes on Ti3C2Tx Mxene Using Vapor Transportation Routine
Next Article in Special Issue
The Tribocorrosion and Corrosion Properties of Thermally Oxidized Ti6Al4V Alloy in 0.9 wt.% NaCl Physiological Saline
Previous Article in Journal
Schlieren Visualization of Shaping Air during Operation of an Electrostatic Rotary Bell Sprayer: Impact of Shaping Air on Droplet Atomization and Transport
Previous Article in Special Issue
Effect of Laser Scanning Speed on the Wear Behavior of Nano-SiC-Modified Fe/WC Composite Coatings by Laser Remelting
Article Menu
Issue 8 (August) cover image

Export Article

Open AccessArticle
Coatings 2018, 8(8), 280; https://doi.org/10.3390/coatings8080280

UHMWPE Nanocomposite Coatings Reinforced with Alumina (Al2O3) Nanoparticles for Tribological Applications

Department of Mechanical Engineering, King Fahd University of Petroleum and Minerals, Dhahran 31261, Saudi Arabia
Received: 28 July 2018 / Revised: 8 August 2018 / Accepted: 12 August 2018 / Published: 14 August 2018
(This article belongs to the Special Issue Nanocomposite Coatings)
Full-Text   |   PDF [8799 KB, uploaded 14 August 2018]   |  

Abstract

Due to a growing demand for protecting metallic components from wear and tear, polymer coatings are being extensively researched and developed as one of the most effective and efficient solutions to reduce friction and wear in demanding tribological applications. The present study focuses on developing a polymer nanocomposite coating of ultra-high molecular polyethylene (UHMWPE) reinforced with different loadings (0.5, 3, 5, and 10 wt %) of alumina to protect steel surfaces. Wear tests were conducted on the coated samples using a tribometer with a ball-on-disk configuration, sliding against a 440C hardened stainless steel ball as a counterface to evaluate the wear life and the load-bearing capacity of the developed coatings. Micro-indentation, energy dispersive X-ray spectroscopy, scanning electron microscopy, and optical profilometry techniques were used to characterize the coatings in terms of hardness, dispersion of the nanofillers, morphology, and wear mechanisms, respectively. Results showed that the UHMWPE nanocomposite coating reinforced with 3 wt % and 5 wt % of alumina did not fail, even until 250,000 cycles at a normal load of 12 N and a linear speed of 0.1 m/s, showing a significant improvement in wear resistance as compared to the pristine UHMWPE coating. View Full-Text
Keywords: coating; UHMWPE; alumina; wear; friction coating; UHMWPE; alumina; wear; friction
Figures

Figure 1

This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. (CC BY 4.0).
SciFeed

Share & Cite This Article

MDPI and ACS Style

Mohammed, A.S. UHMWPE Nanocomposite Coatings Reinforced with Alumina (Al2O3) Nanoparticles for Tribological Applications. Coatings 2018, 8, 280.

Show more citation formats Show less citations formats

Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here.

Related Articles

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Coatings EISSN 2079-6412 Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top