Next Article in Journal
Effect of the Detector Width and Gas Pressure on the Frequency Response of a Micromachined Thermal Accelerometer
Next Article in Special Issue
Liquid Encapsulation in Parylene Microstructures Using Integrated Annular-Plate Stiction Valves
Previous Article in Journal
Focusing Light with Curved Guided-Mode Resonance Reflectors
Article Menu

Export Article

Open AccessArticle
Micromachines 2011, 2(2), 157-166; https://doi.org/10.3390/mi2020157

Ultrasonic Hot Embossing

RWTH Aachen University, Konstruktion und Entwicklung von Mikrosystemen (KEmikro), Steinbachstraße 53 B, 52074 Aachen, Germany
*
Author to whom correspondence should be addressed.
Received: 31 March 2011 / Revised: 3 May 2011 / Accepted: 9 May 2011 / Published: 11 May 2011
(This article belongs to the Special Issue Polymer MEMS)
View Full-Text   |   Download PDF [282 KB, uploaded 11 May 2011]

Abstract

Ultrasonic hot embossing is a new process for fast and low-cost production of micro systems from polymer. Investment costs are on the order of 20.000 € and cycle times are a few seconds. Microstructures are fabricated on polymer foils and can be combined to three-dimensional systems by ultrasonic welding. View Full-Text
Keywords: ultrasound; hot embossing; polymer; micro system; ultrasonic hot embossing ultrasound; hot embossing; polymer; micro system; ultrasonic hot embossing
This is an open access article distributed under the Creative Commons Attribution License (CC BY 3.0).
SciFeed

Share & Cite This Article

MDPI and ACS Style

Schomburg, W.K.; Burlage, K.; Gerhardy, C. Ultrasonic Hot Embossing. Micromachines 2011, 2, 157-166.

Show more citation formats Show less citations formats

Related Articles

Article Metrics

Article Access Statistics

1

Comments

[Return to top]
Micromachines EISSN 2072-666X Published by MDPI AG, Basel, Switzerland RSS E-Mail Table of Contents Alert
Back to Top