Quantifying Cutting and Wearing Behaviors of TiN- and CrNCoated AISI 1070 Steel

doi:10.3390/s8116984

This article is

freely available
re-usable

Sensors 2008, 8(11), 6984-6998; doi:10.3390/s8116984

Article

Quantifying Cutting and Wearing Behaviors of TiN- and CrNCoated AISI 1070 Steel

Ahmet Cakan ¹^,* , Vedat Ozkaner ² and Mustafa M. Yildirim ³

¹ Department of Mechanical Engineering, Abant Izzet Baysal University, Bolu, Turkey ² Department of Electirical-Electronic Engineering, Mustafa Kemal University, Hatay, Turkey ³ Faculty of Technical Education, Department of Metallurgy, University of Firat, Elazig, Turkey

* Author to whom correspondence should be addressed.

Received: 18 September 2008; in revised form: 6 October 2008 / Accepted: 31 October 2008 / Published: 5 November 2008

(This article belongs to the Section Physical Sensors)

Download PDF Full-Text [783 KB, uploaded 4 November 2008 14:51 CET]

Abstract: Hard coatings such as titanium nitride (TiN) and chromium nitride (CrN) are widely used in cutting and forming tools against wear and corrosion. In the present study, hard coating films were deposited onto AISI 1070 steels by a cathodic arc evaporation plating (CAVP) technique. These samples were subjected to wear in a conventional lathe for investigating the tribological behaviour of coating structure, and prenitrided subsurface composition was characterized using scanning electron microscopy (SEM), line scan analyses and X-ray diffraction (XRD). The wear properties of TiN- and CrNcoated samples were determined using an on-line monitoring system. The results show that TiN-coated samples demonstrate higher wear resistance than CrN-coated samples.

Keywords: TiN-coating; CrN-coating; cutting performance; tool wear on-line monitoring; cutting force

Article Statistics

Click here to load and display the download statistics.

Cite This Article

MDPI and ACS Style

Cakan, A.; Ozkaner, V.; Yildirim, M.M. Quantifying Cutting and Wearing Behaviors of TiN- and CrNCoated AISI 1070 Steel. Sensors 2008, 8, 6984-6998.

AMA Style

Cakan A., Ozkaner V., Yildirim M.M. Quantifying Cutting and Wearing Behaviors of TiN- and CrNCoated AISI 1070 Steel. Sensors. 2008; 8(11):6984-6998.

Chicago/Turabian Style

Cakan, Ahmet; Ozkaner, Vedat; Yildirim, Mustafa M. 2008. "Quantifying Cutting and Wearing Behaviors of TiN- and CrNCoated AISI 1070 Steel." Sensors 8, no. 11: 6984-6998.

Sensors EISSN 1424-8220 Published by MDPI Publishing, Basel, Switzerland RSS E-Mail Table of Contents Alert