Fabrication of a ZnO Pyroelectric Sensor
AbstractThis paper proposes a two-step radio frequency (RF) sputtering process to forma ZnO film for pyroelectric sensors. It is shown that the two-step sputtering process with alower power step followed by a higher power step can significantly improve the voltageresponsivity of the ZnO pyroelectric sensor. The improvement is attributed mainly to theformation of ZnO film with a strongly preferred orientation towards the c-axis.Furthermore, a nickel film deposited onto the uncovered parts of the ZnO film caneffectively improve the voltage responsivity at higher modulating frequencies since thenickel film can enhance the incident energy absorption of the ZnO layer. View Full-Text
Share & Cite This Article
Hsiao, C.-C.; Huang, K.-Y.; Hu, Y.-C. Fabrication of a ZnO Pyroelectric Sensor. Sensors 2008, 8, 185-192.
Hsiao C-C, Huang K-Y, Hu Y-C. Fabrication of a ZnO Pyroelectric Sensor. Sensors. 2008; 8(1):185-192.Chicago/Turabian Style
Hsiao, Chun-Ching; Huang, Kuo-Yi; Hu, Yuh-Chung. 2008. "Fabrication of a ZnO Pyroelectric Sensor." Sensors 8, no. 1: 185-192.